www.imoc.co.uk Forum Index
 AlbumAlbum CalendarCalendar FAQFAQ SearchSearch MemberlistMemberlist Legal NoticeLegal Notice IMOC 1/4 Mile1/4 Mile Table Knowledge BaseKnowledge Base   RegisterRegister 
 GarageCommittee GarageGarage  SubscriptionPremium Membership  ProfileProfile   Log in to check private messagesLog in to check private messages   Log inLog in 
Calendar 
5sgte with beams crank pulley & 5s sensor motec

 
Post new topic   Reply to topic       www.imoc.co.uk Forum Index -> MR2 Engine Swaps
View previous topic :: View next topic  
Author Message
rikstergt4




Joined: 28 Mar 2016
Posts: 5

Feedback Score: 0

1995 Toyota gt4 st205

PostPosted: Tue Apr 26, 2016 4:45 pm    Post subject: 5sgte with beams crank pulley & 5s sensor motec Reply with quote Reply with quote including images

Hi everyone I'm looking for the motec ref/sync parameters for the 5sgte 1zz cop's setup with beams crank pulley & 5s crank sensor + hall cam sensor.
If anyone can help please post up your ref/sync motec page for setup reference it will be a great help.
Back to top
User is offline 
ashley




Joined: 13 May 2008
Posts: 7610

Feedback Score: 56



PostPosted: Tue Apr 26, 2016 6:37 pm    Post subject: Reply with quote Reply with quote including images

This is what I've used to initially get the engine running

Back to top
User is offline 
rikstergt4




Joined: 28 Mar 2016
Posts: 5

Feedback Score: 0

1995 Toyota gt4 st205

PostPosted: Tue Apr 26, 2016 8:07 pm    Post subject: Reply with quote Reply with quote including images

Thanks ashley that's a great help I'm trying to save some money & install & setup the motec enough to get it running & hopefully run the engine in before I take it for mapping but it's proving a lot harder than I anticipated.
Back to top
User is offline 
rikstergt4




Joined: 28 Mar 2016
Posts: 5

Feedback Score: 0

1995 Toyota gt4 st205

PostPosted: Wed Apr 27, 2016 10:05 am    Post subject: Reply with quote Reply with quote including images

Did you go with the 1zz dwell setting from the motec site
Back to top
User is offline 
ashley




Joined: 13 May 2008
Posts: 7610

Feedback Score: 56



PostPosted: Wed Apr 27, 2016 1:10 pm    Post subject: Reply with quote Reply with quote including images

No - we used a current probe and scope to measure it- the only data I could find on the Motec site was for 2ZZ coils. That said- it wasn't that different, and when I compared to data from two other people (thanks Mikey on here, and Ryan G)- we were all in the same ball park.

Back to top
User is offline 
Display posts from previous:   
Post new topic   Reply to topic       www.imoc.co.uk Forum Index -> MR2 Engine Swaps All times are GMT
Page 1 of 1

 
Jump to:  
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum


Powered by phpBB © 2001, 2005 phpBB Group